Friday, April 20, 2012

Blend Door Actuator Removal for Dodge & Chrysler?

The Procedure to Replace Blend door actuator.

Please Note that this Procedure Covers all U.S. and Canadian models of the Chrysler/Dodge Avenger, Chrysler Sebring Coupe and Dodge Stratus/ Stratus Coupe models for Year 1999 to 2005

In this chapter  Following details are provided.

Details for Air Mix/Mode Actuator (Blend Door).

Blend door Actuator Removal and installation.

The procedure is as follows:---

1999-00 models use cables to actuate the temperature door and recirculation doors. 2001-05 models use actuators instead of cables. For servicing the cables refer to the Control Cables sections of this product.
See below Help link Provided:---

Control Cables Details and Replacing for Dodge and Chrysler?

http://fordrepairhelp.blogspot.in/2012/04/control-cables-details-and-replacing.html



CAUTION
On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the instrument panel from the vehicle.
  3. Remove the three screws that secure the blend door actuator to the bottom of the HVAC housing. 
    NOTE
    When removing the actuator, note the position of the actuator shaft and its respective linkage for installation reference.


    image
    Fig. Blend actuator (1), mode actuator(2) and harness (3)
  4. Remove the blend door actuator from the HVAC housing and disconnect the HVAC wire harness connector from the actuator.
To install:
  1. Install the blend door actuator onto the bottom of the HVAC housing. If necessary, rotate the actuator slightly to align the splines on the actuator output shaft with those on the blend door cam. 

    image
    Fig. Actuator (1), cam spline (2) and actuator spline (3)
  2. Install the three screws that secure the blend door actuator to the HVAC housing. Tighten the screws to 18 inch lbs. (2 Nm).
  3. Connect the HVAC wire harness connector to the blend door actuator.
  4. Install the instrument panel.
  5. Reconnect the negative battery cable.

These details will help.
Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html




No comments:

Post a Comment