Saturday, October 29, 2011

how to remove blend door actuator on 2003 Ford Focus?

BLEND DOOR ACTUATOR:---

Removal & Installation


  1. Before servicing the vehicle, refer to the Precautions section.
  2. Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection.
  3. Open and unhook the glove compartment.
    NOTE
    The servo motor is hard to access.
  4. Remove the air recirculation flap servo motor.

    Click image to see an enlarged view
    Fig. Blend door actuator access and layout.
To install:

NOTE
The servo motor is keyed onto a shaft. For this reason, the air recirculation flap may have to be pushed into the correct position with the fingertips.

  1. Refit the components in reverse order and check operation.
  2. Reconnect negative battery cable.

------------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------

No comments:

Post a Comment